SUB TRIM
This function applies an auxiliary trim separately to the
servo motor connected to each channel. It should be used
for fine adjustment of the servo horn mounting angle.
However, because there will be an effect on the servo
maximum control surface angle if this amount is moved too
much, it is recommended that the adjustment should be
made over the narrowest range possible.
During adjustment of the Sub Trim amounts, the
By pressing the
REVERSE SW
This function changes the servo operation direction.
Setting is possible for all channels.
When the switches are displayed on the upper side, they
are set to reverse operation.
Setting Method
Determine the channel that you wish to set, and rotate the
dial to highlight the channel display part.
Pressing the dial in this condition will inverse the switch
condition.
Sub Trim Amount
(0 to ±340)
Setting Method
First, determine the channel that you wish to set. By
rotating the dial to highlight the channel display part and
pressing the dial, the channel will become enclosed by a
border. Rotating the dial in this situation will allow increas-
ing and decreasing of the Sub Trim amounts.
After determining the numerical values, press the dial
again.
This will return to the Channel Selection condition.
key, the Sub Trim amounts will return to 0.
Channels that are being set:
LAILLeft aileron
LTALLeft tail
RAILRight aileron
RTAL Right tail
ELEVElevator
LELE Left elevator
RUDD Rudder
RELERight elevator
MOTOMotor
LRUD Left rudder
FLAP Flaps
RRUD Right rudder
AUX2Auxiliary (AUX2)
LFLP Left flap
AUX3Auxiliary (AUX3)
RFLPRight flap
AUX4Auxiliary (AUX4)
LSPILeft spoiler
AUX5Auxiliary (AUX5)
RSPI Right spoiler
AUX6Auxiliary (AUX6)
---- Setting invalid
key will be enabled.
Channels that are being set:
LAILLeft aileron
RAILRight aileron
ELEVElevator
RUDD Rudder
MOTOMotor
FLAP Flaps
AUX2Auxiliary (AUX2)
AUX3Auxiliary (AUX3)
AUX4Auxiliary (AUX4)
AUX5Auxiliary (AUX5)
AUX6Auxiliary (AUX6)
LTALLeft tail
RTAL Right tail
LELE Left elevator
RELERight elevator
LRUD Left rudder
RRUD Right rudder
LFLP Left flap
RFLPRight flap
LSPILeft spoiler
RSPI Right spoiler
---- Setting invalid