JR ProPo DSX11 Operation Manual page 14

Connection and Mounting
In the case of HELICOPTER type
Charging
connector
Antenna
CAUTION
Neither cut off nor bend
the antenna.
Mounting
 Some of the internal parts of the receiver are fragile to the
shock of a drop, vibration, etc.
Be sure to mount so that impact to the airplane is not
directly conveyed to the receiver.
 For mounting, wrap the receiver, batteries, etc. with
rubber foam and fix them with rubber bands.
 After completing the servo's linkage, check whether any
linkage is not in contact with the other or the airplane
body, and confirm that the servo is moving smoothly.
 Some airplanes may use many relay connectors at the
time of mounting. In such case, fix the connectors by
wrapping them with rubber etc., and do not leave the
connectors dangled at all times.
 When mounting the switch harness to the airplane, make
sure that the stroke of the switch moves for sure.
 As to the servo, fix the absorber rubber to the edge, and
then secure it with a screw.
 Use the output shaft's spline to adjust the neutral of the
servo. In such case, adjust the horn by 90 degrees for
cruciform or round, and by 180 degrees for straight line,
respectively.
CAUTION
Do not lubricate or use waterproof spray on the
servo's gear and motor.
Bind plug
Batteries for receiver
Receiver
Spare channel
AUX6
Spare channel
AUX5
Spare channel
AUX4
AUX3
Spare channel
Spare channel AUX2
PIT.
Pitch servo
Gyro sensitivity
adjustment
GEAR
channel
Rudder
RUDD
channel
ELEV
Elevator servo
AILE
Aileron servo
THRO
Throttle servo
CAUTION
The connector has been
trimmed at the corners for
prevention of incorrect
connection of polarity and
to enable smooth connec-
tion. At the insertion, it is
recommended to match
the colors of the wires.