Aile → Rudd - JR ProPo DSX11 Operation Manual

AILE→RUDD MIX
This mixing enables a smooth start to turns by using mixing
to the rudder following aileron operation.
In the situation where you wish to reverse the mixing
Flight Mode Switch
(The aileron stick is set to the LEFT side)
Flight Mode
Position Display
Aileron Operation Direction LEFT: Left side
Setting Method
First, determine the right side or the left side of the position that
you wish to set. By rotating the dial to highlight the display part,
then pressing the dial, this part will become enclosed by a
border. Rotating the dial in this condition will allow increasing
and decreasing of the mixing amount.
Once the numerical values have been determined, press the
dial once again.
when in the Numerical Value Setting
By pressing the
condition , the mixing amount will return to zero.
ELEV→CAMB Mix
This function is used when it is desired to link the camber
with the elevator operation. By setting the mixing so that
the camber is lowered when the elevators are raised, it will
be possible to increase the lift.
Current Transmitter Condition
(Set to the DOWN side)
Setting Method
First, confirm the Up side and Down side of the Flight
Mode that you wish to set. By rotating the dial to highlight
the display part and pressing the dial, this part will become
enclosed by a border. By rotating the dial in this condition,
the mixing amount can be increased and decreased.
Once the numerical value has been determined, press the
dial once more.
By pressing the key when in the Numerical Value
Setting condition, the mixing amount will be returned to
the initial value (0%).
Current stick Condition
Break Point Setting
Mixing Amount (0±125%)
RIGHT: Right side
Press the dial.
Flight Modes
direction, increase the mixing amount in the minus
direction.
Point Setting
(INH, U1 to 100)
Point Setting
(INH, L/R1 to 100)
Break Point Setting
In the situation where the sticks are tilted from the elevator
and rudder optional stick positions, it will be possible to set
the points where the mixing will become invalid. For
example, when the rudder stick has been set to L/R 50, this
mixing will become invalid when the stick is tilted more than
halfway from the center.
Note that it will be possible to set the preset to the "INH"
(inhibited) condition using the
Mixing amounts can be set separately to the Up side and
the Down side.
In the situation where you wish to reverse the mixing
direction, set the mixing amount to minus.
Mixing Amount
(0±125%)
Elevator Operation
Direction
D: Down side
U: Up side
Offset Setting
(0±200)
Snap Operation
Setting (INH/ACT)
Offset Setting (Moving the Mixing Reference Point)
It will be possible to set an optional position on the elevator
stick as the mixing reference point. For example, when set
to "0", the stick center position will become the reference
point.
Snap Operation Setting
By setting SNAP to "ACT", when the elevator stick reaches
the position of the value that was set using OFFSET, the
flaps and flaperons will move to the position that was set.
Flight Modes
Cruise
Speed
Thermal
Launch
Landing
key.
The elevator stick is only set
to the U (Up) side.
The rudder stick is set for both
L/R (left and right) amounts.
Flight Modes
Cruise
Speed
Thermal
Launch
Landing