Trim System - JR ProPo DSX11 Operation Manual

TRIM SYSTEM (System Setting Mode)
Trim Operation
Amount
In this function, setting is carried out of each trim operation
amount and the operation type.
Each trim is adjusted between 1 and 10 as the operation
amount that was moved in one step (The amount moved
when one click is heard).
Pressing the key will set the initial value of 4. Further,
regardless of the setting value set here, when passing
through the neutral point due to the trim operation, the
increasing and decreasing will temporarily stop at the
neutral position (Center Click function).
Trim Type Setting
Trim Type
It is possible to change the operation type of the aileron,
elevator, and rudder trim. Rotate the dial to highlight the
name of the channel that you wish to change. Then press
the dial in this condition to change over the corresponding
switch.
"NORM" is the Normal trim operation. The entire servo
operation range will be changed.
In "L.S.T" (Limit Stroke Trim), the trim amount set at each
stick center (neutral) position will be the maximum, while
the effect of the trim will disappear at the stick end positions.
Accordingly,
determined by the right and left control surface angle
adjustment will not be changed by the trim amounts.
Aileron Rudder Trim:
This determines whether the Trim will be
set for each Flight Mode or will be set
jointly.
the maximum control surface angle