Battery Alarm And Display - JR ProPo DSX11 Operation Manual

Key Input and Key Displays
ENTER Key
LIST Key
CLEAR Key
Function Key
●
As the inputting keys, this transmitter utilizes a dial in
addition to the normal button keys. During setting, almost all
of the operations can be carried out intuitively using this
dial.
The basic method of using the dial is by turning it to the left
and right, and pressing (clicking) it.
●
When inputting is effective, a clicking sound is generated to
confirm the input.
●
Although in some cases only the clicking sound will be
heard even though the displayed numerical value does not
change, this means that the changes in the setting value
are taking place internally in the part below the decimal
point which is not displayed.
●
In the case where the button keys at the left side of the
transmitter have triangular arrow marks shown alongside
them on the LCD display, the keys will operate according to
the button key names. When a key name (abbreviation) is
displayed on the LCD alongside a button key, the key will
have the operation indicated by this abbreviation. When
nothing is shown alongside the key on the LCD display, the
key will not operate.
In this manual, the key displays are as shown in the figures
at right.
Alarm and Error Displays
１ Battery Alarm and Display
When the battery voltage of the transmitter becomes less than
the setting (TX SETTINGS System Mode), "Low Batt" will
begin to flash on the display, and an alarm tone will sound.
If the battery alarm is confirmed while flying the aircraft, set
the aircraft down on the ground as quickly as possible. In
addition, to enable use of the transmitter for a longer period of
time, it is recommended that you operate it with the backlight
switched off.
LCD Display Unit
This is a fixed function that changes the display
ENT
mode when pressed.
When this key is pressed in the normal screen, the setting screen
ENTER Key
of the function mode that was last adjusted using the dial will be
displayed. Further, pressing this key in each of the function
modes will return to the normal screen.
LIST This is a fixed function that displays the listing
screen when pressed.
LIST Key
When rotating the dial during item selection, the
may appear to the right of the arrow mark. Pressing the dial at
this time will show the listing screen. Since this will have the
same operation as the
operation.
Although this key basically sets the setting
CLR
values to their initial values, in the case where
CLEAR Key
an item other than the arrow is shown alongside
the key on the display unit, the key will perform
this item's operation.
Example: NEXT key, etc.
Although this key basically has no role, in the case
where an item is shown alongside the key on the
Function
display unit, the key will perform this item's
Key
operation.
Example: Timer Start/Stop Key
In addition, if this key is pressed simultaneously
while inputting numerical values using the dial, the
numerical values will change at 10 times speed.
２ Warning Message
Depending on the lever switch and throttle stick conditions in
the situation where the power switch has been switched on
and "RF-ON" has been selected, a message notifying the
operator of the situation may be shown together with an alarm
sound. When the throttle stick and lever switches are all set to
their normal conditions the radio wave output will switch ON
and the screen will change to the normal display screen.
It will be possible to change the settings using the Warning
Settings (System Setting Mode).
* In the situation where a setting has been mistakenly made
from which the warning cannot be released, pressing the
rotary switch will move to the Warning Setting screen where
you should change to the appropriate settings.
Dial
By turning this to the
right and left, item
selection and setting
value increasing or
decreasing can be
carried out.
Further, by pressing
(clicking) the dial, it
will be possible to
determine the
selected item and to
exit from the setting
screen.
abbreviation
key, please make use of this
LIST
When the rotary switch is pressed, the screen
will move to the Warning Setting screen.