JR ProPo DSX11 Operation Manual page 40

STICK POSition SW
In this function, by setting the boundary lines for an optional
stick operation area, it will be possible to carry out opera-
tion as though using a switch.
By carrying out this setting, the SPS items that could not
Setting Method
First, rotate the dial to highlight the number of the item that
you wish to set from either SPS0 or 1, and press the dial.
This will cause the part to become enclosed by a border, and
selection will be possible by rotating the dial.
After determining the stick that you wish to use, press the
dial one more time. The items and diagrams will appear as
shown in the figure below.
In this situation, up will be ON, and down will
be OFF, as shown in the bar graph at the right.
In this
situation, up
will become
ON.
In "POS", the ON/OFF boundary line can be set, and when
the value is zero the area on both sides will become in the
condition of being divided in half. Further, it will be possible
to carry out settings to allocate the stick to either one of the
sides as the area where "AREA" is set to ON. In the
previously be set in "SW SE L" in each of the mixing
screens will be able to be selected.
Further, this function can be used not only in the mixing, but
also in the Timer operation.
Condition
Stick Selection
Transmitter Condition Display
ON
OFF
ON OFF
situation where both ends are to be allocated as the
ON/OFF areas, set "SYM" to ON.
It is possible to set combinations of "ON" and "SYM", so that
the "POS" value will be zero when the stick is in the center,
and will become 100 when the stick is at both ends.
Item Selection Condition
Press the dial.
Stick Selection Condition
When this is set to ON,
changeover will take place at
both ends and in the center.
In this situation, both ends
will become ON.
ON