Monitor - JR ProPo DSX11 Operation Manual

MONITOR

This function is for monitoring the servo operation and
A.D.T. amount of each channel that incorporates a servo
operation testing function using the transmitter display
screen. In the servo operation display, the horizontal line in
the center of the bar display is the neutral position. From
this as the center, graduations for the control surface 50%
and 100% angle positions are marked in order in the up and
down directions, and both ends in the up and down
directions will become the maximum control surface angles
Servo Operation Display
Match the cursor to
and press the dial, or else
press the function key.
Trim Amount Display
Servo Test Operation Changeover
The Servo Test switches between the TEST parts
in the Servo Operation Screen. When the dial is
rotated the items will change as shown in the figure
at right.
NEUTRAL: All servos are neutral
Slow : All servos will operate
slowly at the same time.
Quick : All servos will operate
quickly at the same time.
Step : Each servo will operate on
each side in succession.
In this Servo Testing, only the Limit Adjust will
operate effectively.
of 150%.
The movements in this function will be movements that
include all adjustments and mixing. Regarding each of the
display positions, these should be used as a rough guide.
It is then possible to confirm the trim amounts from the list
of trim amounts that are displayed separately for each
Flight Mode. The screens can be switched using the PAGE
key.
Servo Operation Test
0%
50%
100%
150 %
Channels that are being set:
LAILLeft aileron
RAILRight aileron
ELEVElevator
RUDD Rudder
MOTOMotor
FLAP Flaps
AUX2Auxiliary (AUX2)
AUX3Auxiliary (AUX3)
AUX4Auxiliary (AUX4)
AUX5Auxiliary (AUX5)
AUX6Auxiliary (AUX6)
AUX7Auxiliary (AUX7)
GYR5Gyro
LTALLeft tail
RTAL Right tail
LELE Left elevator
RELERight elevator
LRUD Left rudder
0%
RRUD Right rudder
50%
LFLP Left flap
100% RFLPRight flap
LTIP Left Tip Aileron
150%
RTIPRight Tip Aileron
LSPILeft spoiler
RSPI Right spoiler
---- Setting invalid
The figure at left shows the situation
where "Flight Mode" has been set in
Device Select (System Setting Mode).
Test Halted Condition
Press the dial.
All Servos Neutral (Stopped)
Press the dial.
All Servo Test Condition
(Slow Operation)
Press the dial.
All Servo Test Condition
(Fast Operation)
Press the dial.
All Servo Test Condition
(Step Operation)