Wing Type Selection - JR ProPo DSX11 Operation Manual

(2) During Glider Type Selection
This receiver allows V-tail, elevator, rudder, dual flap, and
dual spoiler wing mixing.
In addition, differential amount adjustment is possible.
V-tail Setting
Wing Type Selection
Situation when using V-tail (V-tail aircraft)
The servo connected to ELEV is used for the left tail moveable part, and the
servo connected to RUDD is used for the right tail moveable part. When the
V-tail setting is changed to active (ACT), V-tail operation will be set. At this
time, the operation amount of each servo will automatically become 75%. In
addition, because the adjustment of the left and right control surface angles
of the corresponding channels will be carried out for each servo, the adjust-
ment of the operation amount using each stick operation should be imple-
mented using each Dual Rate. Further, the reverse setting of each servo
should be carried out corresponding to each servo. In addition, the adjust-
ment of each servo to the neutral position should use the Sub Trim.
When this setting is carried out, the channel names will change as
described at right.
Situation when using Dual elevators, Rudders, Flaps, and Spoilers
By setting the MATE channel of each control surface, it will become possible
to carry out dual operation, where the output channel will be MOTO, FLAP,
or AUX2~6. In addition, the adjustment of the left and right control surface
angles of the corresponding channels should be carried out for each servo.
The reverse setting of each servo should be carried out corresponding to
each servo. In addition, the adjustment of each servo to the neutral position
should be implemented according to the Sub Trim section.
SPOI STick DIRection (Glider System Setting Mode)
This function is used in Glider Mode when you wish to
reverse the upper/lower direction of the spoiler stick.
Pressing the dial in the condition shown in the following
figure will alternate switching between Normal (Stick lower
position is the spoiler open position) and Reverse (Stick
upper position is the spoiler open position).
Setting Method
By rotating the dial to highlight the item that you wish to set,
then pressing the dial, the item will be set to the Selection
condition. Rotate the dial to select the switch that you wish
to set from the list that appears, and press the dial.
In addition, the
Pressing the
(condition shown in the figure below).
Setting of each control surface to
dual operation (using two servos)
key will be effective during selection.
key will return to the initial conditions
To Device Select
Dual Spoiler Setting
Connect to ELEV Connect to RUDD
3ch
LTAL
Channel Name Changes
Change in the Reverse Switch, Sub Trim, left
and right control surface angle adjustment,
Throttle Curve, and Servo Speed
ELEV→LTAL (Left Tail)
RUDD→RTAL (Right Tail)
4ch
RTAL