Thro Trim - JR ProPo DSX11 Operation Manual

THRO TRIM

Switch Selection
In this function, the Throttle Cut and Throttle Trim Memory
operations are set.
Throttle Cut
It is not possible to set Throttle Cut and Throttle Trim
Memory to ACT (activated) at the same time.
In Throttle Cut, it is possible to select the Throttle Position,
Time Lag, and the switches.
Use the Time Lag in situations such as where you wish to
jointly use the Timer Switch with the switches. By setting the
selected switch, when the time becomes continually ON,
the Throttle Cut will operate.
In the situation where Twin Engine has been set in the Wing
Type (System Setting), each engine can be set.
Throttle Down Amount
Idling Adjust Amount
Time Lag Setting
Throttle Trim Memory
*This cannot be set at the
same time as Throttle Cut.
Switch Selection
Throttle Trim Memory
In the situation where the Throttle Trim Memory has been
set to ACT, limited to the case where the Throttle Trim is
moved once down to its lowest position, the trim position
immediately prior to the movement will be memorized.
Afterwards, when the trim is raised, it will move to the
memorized position.
Idling Adjust
During idling flight, the Idle Up/Down when landing can be
changed over using the switch. Positive numerical values
will be up, while negative numerical values will be down.