Gyro Sens - JR ProPo DSX11 Operation Manual

GYRO SENS adjust
The Gyro Sensitivity changeover can be switched manually
either or by the D/R switches and Flight Mode switches
using the GEAR, AUX2, or AUX3 channels, or switched
automatically in each Flight Mode.
The setting of which channel is to be used for changing
over the sensitivity is carried out in Device Select (System
Mode).
In the initial settings, the GEAR (5) channel is set to allow
changeover using the RUDD D/R switch.
By pressing the dial after highlighting the switch selection
Operation
Changeover
2 Position SW
3 Position SW
Flight Mode SW
During Auto Sensitivity Changeover
During the Auto Sensitivity Changeover (in AUTO setting),
it will be possible to set the sensitivity for each Flight Mode.
In the situation where the Flight Mode Extension function
has been set, it will also become possible to set Stunt 3 and
4.
In addition, by setting Throttle Hold to activated, it will also
become possible to select the sensitivity during the Throttle
Auto Sensitivity
Current Transmitter Condition
Changeover Mode
(Set to the Pos0 side)
When using Two Gyros
In this transmitter, it is possible to set the sensitivities for
two gyros. Device Select (System Setting Mode) should be
used for the settings. However, the channels that can be
selected will be GEAR, AUX2, and AUX3. When two gyro
units have been set, the display will become as shown
below, and it will be possible to carry out the setting for each
gyro.
part, it is possible to select the changeover switches or
AUTO operation. The following screen shows the situation
when manual changeover (changeover using the RUDD
D/R switch) has been activated.
For the adjustment of the sensitivity, first rotate the dial to
highlight the characters of the Pos0, 1, or 2 sensitivity part
and press the dial. Next, rotate the dial to carry out the
adjustment. In addition, while adjusting the setting
amounts, pressing the
returned to 50%.
Current Transmitter Condition
(Set to the Pos0 side)
Delay Time
Hold situation using this screen.
Rotate the dial to highlight the Flight Mode sensitivity
amount part that is to be set and press the dial. Then rotate
the dial to set the sensitivity amount.
In addition, during adjustment of the setting amount, the
possible to return the value to "50%".
Gyro Sensitivity
Switch Position
Although the figure below shows the settings in "AUTO", it
will also be possible to change over using each of the
switches. In this situation, the changeover between the
three positions will jointly switch the two gyros using the
switches that have been set.
key will allow the setting to be
Output Channel
Gyro Sensitivity
Switch Position
Amount (0 to 125%)
key becomes enabled. By pressing this key, it will be
Normal: 0 to 125%
Tail Lock: 0 to 150%
Switch Position
NORM: Normal
ST-1: Stunt 1
ST-2: Stunt 2
ST-3: Stunt 3
ST-4: Stunt 4
HOLD: Throttle Hold
Only displayed during setting
Gyro Type