Program Mix 1~6 - JR ProPo DSX11 Operation Manual

PROGRAM MIX 1~6

This transmitter incorporates six systems of program
mixing. The three internal mixing systems 4-6 utilize curve
mixing that allows the mixing amount to be freely set using
an optional master channel position.
The display below shows the situation when Mixing 1 is
activated (ACT).
Before setting this item, first confirm whether or not the
 Mixing 1~6 Normal Mixing Setting
Slave Channel
Master Channel
(Channel to which
(Channel that applies
mixing is applied)
the mixing)
Offset Amount (±200)
Channel Setting
By highlighting the Master channel (or Slave channel) part
and pressing the dial, the Channel Selecting screen will be
displayed. Select an optional channel from this screen.
Rotate the dial to match the channel that you wish to set,
and press the dial once again to determine it. At this time,
"CANCEL" will be displayed at the top right. If this key is
selected, the channel selection will return to the condition
that it was in before starting the selection.
After selecting the Master Channel, using the screen that is
displayed it will be possible to select whether or not to apply
mixing, including the mixing that influences the Master
Channel such as Master Channel Trim and Dual Rate.
Operation Switch Selection Method
Each program mixing can also be switched ON/OFF using
the optional lever switches. The display of the lever
switches that can be selected, and the positions when they
are set to ON are as described below.
Note: In the situation where the Flight Modes and SPS have
not been set, each of these will be displayed in gray,
and setting will not be possible.
Current Transmitter
Condition (Set to Pos0)
Throttle Stick Linkage Position
(INH, 0 to 100)
current positions of all the servos should be fixed (HOLD).
Because the throttle stick will be moved during the adjust-
ment afterwards, select "YES" if adjustment is to be carried
out while the engine is still rotating.
In the situation where this item is entered using Servo Hold,
set the throttle stick to the slowest position to exit from the
item.
Operation Switch Selection Method
Each program mixing can also be switched ON/OFF using
the optional lever switches. The display of the lever
switches that can be selected, and the positions when they
are set to ON are as described below.
Mixing Release
In the situation where you wish to release this function,
press the key when the Master Channel is selected.