Servo Speed - JR ProPo DSX11 Operation Manual

SERVO SPEED

This function allows the operation speed of the servo
connected to each channel to be changed (made slower).
It is possible to change the speed linked to the operation
direction of each channel and each switch position.
The speed is set over a range of NORM, 0.176, ... 15.0,
and this numerical value shows the time (in seconds) taken
for the servo to move through an angle of 60 degrees.
Normal (NORM) is the normal operation speed, which will
Current Transmitter Condition
Setting Method
For the value setting, by rotating the dial to highlight each of
the operation direction parts of the channel that you wish to
set, then pressing the dial, the part will become enclosed by
a border. In this situation, rotate the dial to change the
setting amount.
Pressing the dial once again will return to the Selection
condition. Further, by pressing the
the setting amount, it will be possible to return the setting to
"NORM".
Operation Switch Selection Method
By rotating the dial to highlight the "SW SEL" part and
pressing the dial, it will be possible to select the switch
positions as shown in the figure at right.
Normally the "ON" button is selected, and is always in the
operating condition.
By selecting the right side button, the "ON" button will
become "OFF", and the settings will operate according to
the condition of the buttons selected by each switch.
NORM, ST-1, 2, 3, 4, and HOLD will be "ON" when the
Flight Modes are set to Normal, Stunt 1, 2, 3, 4, and Throttle
Hold. SPS 0 and 1 are used during changeover using the
Stick Position switches. Note that in the situation where
these are displayed in grey, the buttons will be displayed
normally by setting each switch function, and selection will
become possible.
Throttle Stick Linkage Setting
It is possible to set optional throttle stick positions as the
mixing changeover points. For example, if 50 is set, raising
the stick from the center will be the normal situation, and
lowering the stick will change to the value that was set (ON
condition).
Set the stick to the desired changeover position, and press
the "STO" key.
To confirm the linked position, move the throttle stick and
confirm the changeover point for the upper and lower
values using the condition display.
Note that it will be possible to use the
INH (inhibited condition).
be the fastest speed for the servos utilized. Because the
fastest speed will depend on the servos that are being
used, refer to the rating of the servo that you are utilizing.
For example, in the situation when using a 0.2 sec/60°
servo, the servo will operate at a speed of 0.2 sec/60° even
if the setting is "0.176".
Be sure to carefully confirm the actual servo operation
direction before carrying out the setting.
key while adjusting
Press the dial. Match to "SW SEL" and press the dial.
Buttons displayed in gray show that the functions have not been set.
In the situation where you wish to select the buttons, set the functions.
key to preset to
Channels that are being set:
THROThrottle
AILE Aileron
ELEVElevator
RUDD Rudder
GEAR Gear (Retractable
landing gear)
PIT. Pitch
AUX2Auxiliary (AUX2)
AUX3Auxiliary (AUX3)
AUX4Auxiliary (AUX4)
AUX5Auxiliary (AUX5)
AUX6Auxiliary (AUX6)
---- Setting invali
CH-* Display during Swash Setting
Item Selection Condition
Press the dial.
Numerical Value Setting Condition
(During DSM: NORM, 0.176, ... 15.0)
Item Selection Condition
Press the dial.
Numerical Value Setting Condition
(NORM, 0~100)