JR ProPo DSX11 Operation Manual page 97

(3) During Glider Type Selection
In this function, it will be possible to change the Flight
Mode Extension function, the left and right levers, and
each switch allocation, and to set whether or not they are
used. Care will be required that the allocations are not
duplicated, since the functions will move simultaneously.
In the situation when selecting the input device, a graphic
showing the input device position will be displayed
together with the name, as shown in the figure at bottom
right.
To Wing Type
Flight Mode Switch Selection
Flight Mode Setting
Five systems of Flight Mode settings are possible. The
SPEED items can be switched between Speed, Cruise,
and Thermal, while the LAUNCH items can be switched
between Launch, Cruise, and Landing settings. Note that in
the situation where two-position switches are selected for
LAUNCH switching, it will only be possible to switch
between Launch and Cruise. In the Flight Mode, the
Launch condition is given the highest priority. The switches
that can be selected will be three-position switches for
Flight Mode Speed Switch Position
Launch Switch:
When set to INH
Position 0 (Above or Side Away from You)
Launch Switch:
When set to 2P
Position 1 (Below or Side Towards You)
switch
Position 0 (Above or Side Away from You)
Launch Switch:
Position 1 (Center Side)
When set to 3P
switch
Position 2 (Below or Side Towards You)
Reverse Setting
The Launch switch operation direction can be reversed.
Normally the switch position towards you will be the Launch
Mode, and the switch set on the side away from you will be
the released setting. However, when this switch is set to
REV., the switch position away from you will be the Launch
Mode, and the switch set on the side towards you will be the
released setting.
Setting Method
By rotating the dial to highlight the item that you wish to set,
then pressing the dial, the item will be in the selected condition.
Rotate the dial to select the switch that you wish to set from the
list that appears, and press the dial. In addition, the
be effective only during the Input Device Selection. By pressing
the
shown in the figure below).
Launch Mode Switch Selection
Launch Switch Operation Direction Changeover
0 1
Speed (SPEE) Cruise (CRUI)
Speed (SPEE) Cruise (CRUI)
Launch (LAUN) Launch (LAUN)
Speed (SPEE) Landing (LAND)
Speed (SPEE) Cruise (CRUI)
Launch (LAUN) Launch (LAUN)
key the value will return to the initial condition (situation
Motor Channel Input Device and Output Condition
Flap Channel Input Device and Output Condition
AUX2 Channel Input Device and Output Condition
AUX3 Channel Input Device and Output Condition
AUX4 Channel Input Device and Output Condition
AUX5 Channel Input Device and Output Condition
AUX6 Channel Input Device and Output Condition
Output Condition
(Whether or not the input device is used)
ACT: Send output from allocated
INH: Input invalid
SPEED, and any of the switches except for the Trainer
switch for LAUNCH. By setting any switch to enabled, it will
be linked to the Flight Mode by many of the Function Mode
functions, and it will be possible to automatically change
over the setting values.
In the normal display, the Flight Mode conditions described
below will be displayed.
2
Thermal (THRM)
Thermal (THRM)
Launch (LAUN)
Thermal (THRM)
Thermal (THRM)
Launch (LAUN)
key will
equipment
(Input/output is disconnected)