JR ProPo DSX11 Operation Manual page 47

THROttle CURVE
In this function, the throttle curve settings are carried out.
Setting is possible for each stick position, and the adoption
of a multipoint adjusting method allows various adjustments
to be freely carried out to create throttle curves that will
enable ideal flight conditions. Using the graph display, it will
be possible to intuitively understand the operation.
In addition, it will also be possible to create linkages with
Position Display
Point Number
Throttle Stick
Switch
Switch
Selection
Setting Method
First, rotate the dial to highlight the "POS0" part as shown in
the figure above, then press the dial to change between
"POS0" and "POS1" and allow selection. Here, setting is
possible for each position, and as an example the Pos0
side is normally set to "Straight Line Operation" to allow
setting that will enable Pos1 to be changed to "Curve
Operation" by the operation of specific switches.
It is also possible to carry out setting so that Pos0 will also
become "Curve Operation".
About the Intermediate Points
In the initial conditions, the setting is as shown in the graph
where Intermediate Point 1 is set to the 50 location for both
Pos0 and Pos1. Note that Intermediate Points can be set to
optional positions along the curve, and the number of points
can be increased to a maximum of three locations.
In the situation where Intermediate Points are to be added
or deleted from this condition, move the stick to match the
cursor to the location where you wish to make the setting. If
setting is possible, the STO key will be displayed, and the
point will be added by pressing the key. The Point name will
automatically change to 1 and 2 counting from the left.
This will change according to the stick position.
ADD: Add point DEL: Delete point
each Flight Mode to allow changeover.
Before setting this item, first confirm whether or not all the
servos are to be fixed (HOLD) at their current positions.
Because the throttle stick will be moved in the following
adjustment, select "YES" when the adjustment is to be
carried out while the engine is still rotating. Note that
throttle hold will be prioritized in the Throttle Hold condition.
Stick Position of
Corresponding
Corresponding
Point
Point Output Graph Display
Value (0 to 100)
Exponential
Current Stick
Function
Position
Point Numerical Value Input
The numerical value setting for each point is also carried
out by rotating the dial to highlight the point that you wish to
set, then pressing the dial so that the point changes to the
condition where it is enclosed by a border as shown in the
figure below. Rotating the dial in this condition increases or
decreases the numerical value, while pressing the
in this condition returns the value to the preset value.
When preset is carried out,
Further, to delete a point, in the same way as for the
addition method move the stick to match the cursor to the
point that you wish to delete and press the function key.
Note that in the situation where the point that you wish to
set is located too close to another point, nothing will be
displayed, and setting will not be possible. Avoid setting
unnecessary points as far as possible.
The display in the figure to the left
shows the situation in the initial
conditions when the position is Pos0,
the throttle stick is centered, and the
Throttle Trim is neutral.
Current Output
Amount
Press the dial.
L: Becomes an output value of 0.
Intermediate Point: Becomes an auxiliary value of the
upper and lower point output values.
H: Becomes an output value of 100.
Trim
Operation
Ranges
L 1
Low
Throttle Stick
(Graph 1) Initial Condition Operation
(Condition where the intermediate
point is only "1")
key
(Output Value)
100
50
Range where
Trim Setting is
not possible
0
H
High