JR ProPo DSX11 Operation Manual page 73

Elevator Stick Setting (2/3)
Using the items on the following page, it will be possible to
set the Break Point as an Elevator Stick optional position.
For example, when set to U50, the Delay operation will be
suspended if the elevator stick is moved from the center
below the lower half.
Trim Setting (3/3)
This setting allows setting of which Trim Levers the Flap
and Flaperon Trim will be allocated to in each Flight Mode.
In addition, in the situation where levers (LV) have been
selected, it will be possible to offset the center positions.
Setting Method
Press the dial and select the desired switch (SPOI TR,
FLAP TR, AUX TR, FLAP LV, or AUX3 LV).
In the situation where LV has been selected, it will be
possible to offset the lever center.
The Camber System Trim has the same moveable range as
the normal stick input.
Flap Trim Switch Selection Flaperon Trim Switch Selection
In the situation where FLAP
LV and AUX3 LV have been
selected, it will be possible to
change the lever center
positions by inputting lever
offsets.
Actually move the stick position, and press the STO key to
input the position.
Note that it will be possible to return to the initial value of
U50 by pressing key.
This is input using the elevator stick
position, and determined using STO.