Model Select; Copy/Erase - JR ProPo DSX11 Operation Manual

Method of using the System Setting Mode
By selecting SYSTEM LIST in the Function Mode, the System Setting Mode List screen will be displayed.
In this Mode, the basic settings are carried out.
MODEL SELECT (System Setting Mode)
This transmitter is capable of storing all the settings of 30
different aircraft settings and different Type settings.
Because the Type Selection function can also be freely
carried out for each model, it will also be possible to use this
to carry out multiple functions.
Model Selection Function
By pressing the dial in the condition shown in the figure
above to enter the Model Switching condition (see figure at
right), it will be possible to rotate the dial to select the
models in order of appearance. Pressing the dial once
more will confirm the model.
COPY/ERASE (System Setting Mode)
This function allows all of the setting data of an existing
Model to be transferred to another Model or to be deleted.
Model Copy
Situation of INTERNAL (Internal Memory)
Rotate the dial to move the cursor to Copy Source Model
Selection, and press the dial.
Select the Model that you wish to Copy, and press the dial
again. Then also select the Copy Destination Model at the
same time, and press the COPY key.
Copy Source
In this situation, the
source is the Internal
Memory, Model 1 Glider
DSM
Copy Destination
In this situation, the data
will be copied to Internal
Memory Model 2.
In the situation where
there is data memorized
in the Copy Destination,
Copy will not be
possible.
The data should first be
deleted.
Be absolutely certain not to pull out or insert the SD Card during this Mode.
There will be a danger that the data will be lost.
Model Number (1 to 30) Type
Modulation
INTERNAL

CAUTION!!
Model 1 can be stored as a helicopter, Model 2 as an
airplane, etc. Note that the Model Name (see next section)
should be employed to make sure that you do not mistake
the model selection.
Display of Model Name, if it has been set.
Caution Items
The data of the Model to which the setting data is
transferred will be overwritten by the transferred new data
and deleted. Since it will not be possible to undo the Copy
function, care should be taken with its use.
SD Cards that can be used are cards which are 16GB or
smaller in size that have been formatted in FAT (32, 16).
Existing Model
Copy Source
Model Selection
Copy Destination
Model Selection