Gyro Sens - JR ProPo DSX11 Operation Manual

GYRO SENS ADJust
The Gyro Sensitivity changeover can be switched manually
using each of the D/R switches and Flight Mode switches,
or switched automatically in each Flight Mode.
The setting of which channel is to be used is carried out in
Device Select (System Setting Mode).
By pressing the dial after setting the switch selection part to
the highlight condition, it is possible to select the change-
over switches or AUTO operation. The following screen
Operation
Changeover Switch
In the situation where
these switches have been
selected, it is possible to
set up to Pos2.
Only during Flight
Mode setting
During Auto Sensitivity Changeover
During the Auto Sensitivity Changeover (During AUTO
setting), it is possible to set the sensitivity for each Flight
Mode.
Use the dial to highlight the Flight Mode sensitivity amount
part that is to be set and press the dial. Then rotate the dial
to set the sensitivity amount.
Current Transmitter
Condition (Set to Pos0)
Auto Sensitivity
Changeover Mode
When using Two Gyros
In this function, it is possible to set each of the sensitivities
when two gyros are incorporated.
Use Device Select (System Setting Mode) beforehand to
enable each of the gyro allocations. When they have been
enabled, the screen will become as shown below.
shows the situation when manual changeover (Changeover
using the AILE D/R switch) is activated.
In the adjustment of the sensitivity, first rotate the dial to
highlight the characters of the Pos0, 1, or 2 sensitivity part
and press the dial. Next, rotate the dial to carry out the
adjustment. In addition, while adjusting the setting amounts,
pressing the
50%.
Current Transmitter Condition
(Set to the Pos0 side)
Delay
*The delay only operates when changing from low sensitivity to high sensitivity.
In addition, during adjustment of the setting amount, the
out Clear operation.
By pressing the key, it will be possible to return the value to
50%.
Gyro Sensitivity Amount (0-100%)
Switch Position
Although the figure below shows the settings in "AUTO", it
is also possible to change over using each of the switches.
In this situation, the gyro sensitivity switching should be
carried out for each of the two optional switch positions.
key will allow the setting to be returned to
Channel that has been set
Gyro Type
Switch Position
key becomes enabled and it will be possible to carry
Switch Position
FM-0: Flight Mode 0
FM-1: Flight Mode 1
FM-2: Flight Mode 2
Gyro Sensitivity Amount
(0-125%)