JR ProPo DSX11 Operation Manual page 95

(2) During Airplane Type Selection
In this function, it will be possible to change the Flight
Mode Extension function, the left and right levers, and
each switch allocation, and to set whether or not they are
used. Care will be required that the allocations are not
duplicated, since the functions will move simultaneously.
In the situation when selecting the input device, a graphic
showing the input device position will be displayed
together with the name, as shown in the figure at bottom
right.
To Wing Type
Flight Mode Switch Selection
Flight Mode Setting
It will be possible to set whether the Flight Mode will be
used or not, and to allocate the switches for the operation.
The switches that can be selected are the three-position
switches.
Setting Method
By rotating the dial to highlight the item that you wish to set,
then pressing the dial, the item will be in the selected condition.
Rotate the dial to select the switch that you wish to set from the
list that appears, and press the dial. In addition, the
be effective only during the Input Device Selection. By pressing
the key the value will return to the initial condition (situation
shown in the figure below).
Gear Channel Input Device and Output Condition
Flap Channel Input Device and Output Condition
AUX2 Channel Input Device and Output Condition
AUX3 Channel Input Device and Output Condition
AUX4 Channel Input Device and Output Condition
AUX5 Channel Input Device and Output Condition
AUX6 Channel Input Device and Output Condition
Output Condition
(Whether or not the input device is used)
ACT: Send output from allocated
equipment
INH: Input invalid
(Input/output is disconnected)
GYR: Gyro setting effective
PT2: Pitch 2 settings are effective
(Only when set to Swash 1-servo)
key will