Trim System - JR ProPo DSX11 Operation Manual

TRIM SYSTEM (System Setting Mode)
Trim Operation
Amount
In this function, setting is carried out of each trim operation
amount and the operation type.
Each trim is adjusted between 1 and 10 as the operation
amount that was moved in one step (The amount moved
when one click is heard).
Pressing the key will set the initial value of 4. Further,
regardless of the setting value set here, when passing
through the neutral point due to the trim operation, the
increasing and decreasing will temporarily stop at the
neutral position (Center Click function).
Throttle Hold
This function will be set to ON when the Twin Engine
function is activated (Changed using System Setting Mode
and Wing Type). In the standard condition, the Mixing
switch at the top left rear of the transmitter will become
available to use.
Press the dial.
The Throttle Hold position value will be variable over a
width of -20 to +50% using the throttle position while Hold
is applied. Because the output amount during idling will be
a minimum of zero in the Throttle Curve, if settings are
made lower than this (here meaning minus values) it will be
possible to set the throttle to the fully closed position and
stop the engine.
In addition, it will be possible to change the allocation of the
HOLD switch.
Only during Flight Mode Setting
Trim Type Setting
Trim Type
It is possible to change the operation type of the aileron,
elevator, and rudder trim. Rotate the dial to highlight the
name of the channel that you wish to change. Then press
the dial in this condition to change over the corresponding
switch.
"NORM" is the Normal trim operation. The entire servo
operation range will be changed.
In "L.S.T" (Limit Stroke Trim), the trim amount set at each
stick center (neutral) position will be the maximum, while
the effect of the trim will disappear at the stick end positions.
Accordingly,
determined by the right and left control surface angle
adjustment will not be changed by the trim amounts.
In the situation where the numerical vales are to be set,
after setting the ACT condition, rotate the dial to highlight
"HOLD POS." Clicking the dial will change to the Numerical
Value Setting condition.
Throttle Hold Position (-20 to +50%)
Stunt Trim:
(Only when setting using Device Select)
This determines whether the trim is applied to
all modes jointly, or whether it is set for each
Flight Mode.
Flap Trim:
This sets whether or not Flap Trim is to be
used.
Cross Setting
THRO/ELEV:
When CROSS is selected, the left and right
trim will be substituted.
FLAP/AUX:
When CROSS is selected, the left and right
trim will be substituted.
the maximum control surface
"ON" will be displayed in the situation
where the Hold switch is ON.
Switch Selection
Item Selection Condition
Numerical Value Setting
Condition (-20 to +50%)
By rotating the dial, it is possible
to increase or decrease the
numerical values.
Using the key, the value can
be set to the preset (0%).
angle