JR ProPo DSX11 Operation Manual page 48

When an Intermediate Point is added, the points above
and below this point will be automatically displayed as the
output values in the situation where the points are linked in
a straight line condition.
Further, by setting the Intermediate Points as shown in the
graph, they will lie in a straight line. From this condition, it
will be possible to freely set the curve. Because the graph
display will include display of the throttle trim operation,
caution will be required.
Further, whether or not Intermediate Points should be
added will also require consideration of the aircraft body
setting condition. Curves should be set to match the
purposes of each performance.
Throttle Trim Allocation
For the Throttle Trim, it will be possible to increase or
decrease the Point L output as shown in the graph.
Further, as shown in the graph the trim operation will exert
an influence on the operation up to the next point.
Operation Switch Selection Method
By rotating the dial to highlight the "SW SEL" part, then
pressing the dial, it will become possible to select the
switch positions as shown in the figure below. The switch
positions will determine which of the position values will be
employed for Pos0 or Pos1.
Press the dial.
Match the cursor to SW
SEL and press the dial.
Throttle Stick Linkage Setting
It is possible to set an optional throttle stick position as the
changeover point for this setting.
For example, in the situation where the value has been set
to 50, the throttle stick will be Pos1 until the throttle stick is
moved past the center, and will change over to Pos0 when
the throttle stick is moved past the center. However, if either
the stick value or the switch is set to "POS1", the value set
to Pos1 will be used.
Note that it will be possible to preset to INH (function
inhibited) using the key.
Exponential Curve (EXP) Function
Curves are independent for each system, and it is possible
to select a straight line or an exponential curve. By setting
EXP to ON using the dial, the sequential line curve will
become an exponential curve in which the changes in the
output values close to each of the points will become
smoothed. To set this function to OFF, press the dial again
to switch it OFF.
During Twin Engine Setting
By setting Twin Engine setting using Wing Type (System
Setting Mode), the position will have two systems added,
and it will be possible to separately adjust the throttle
curves for the left and right engines. "RTH0" and "RTH1"
are the positions for the RTHR (Right Throttle) channel,
while "LTH0" and "LTH1" are the positions for the LTHR
(Left Throttle: Selection channel that has been set)
channel.
Throttle Trim
Operation Range
(Points) L 1 2
Low
Throttle Stick
Situation of switch position "N" where
Intermediate Points have been added.
Mixing Switch Selection Switch Positions
By setting AND to ON, all of the switches satisfying the
condition of being set to P1 will become Pos1.
Press the dial
Press the dial.
Press the dial.
(Output Value)
100%
50%
0%
3 H
High
Item Selection Condition
Numerical Value
Setting Condition
(INH, 0 to 100)
*Match the throttle stick
to the desired position
and press the STO key.