Device Sel - JR ProPo DSX11 Operation Manual

DEVICE SELECT (System Setting Mode)
(1) During Helicopter Type Selection
In this function, it will be possible to change the Flight Mode
Extension function, the left and right levers, and each switch
allocation, and whether or not they are used. Care will be
required that the allocations are not duplicated, since the
functions will move simultaneously. In the situation when
selecting the input device, the device will be selected by
actually moving the input device that you wish to select.
Flight Mode Switch
Selection
To the Swash Type
Flight Mode Extension Function
Flight Mode Switch
It will be possible to change the Flight Mode switches. The switches that can be
selected are the Flight Mode switch and the RUDD D/R switch.
Flight Mode Extension Function Switch
It will be possible to set the Extension switch to be linked with the Flight Mode
switches. By setting this switch, it will become possible to use the Flight Mode
switches to switch between Normal, Stunt 1, and Stunt 2, and between Normal,
Stunt 3, and Stunt 4. The condition of each of the switch positions is as
described in the table below. Note that when "INH" is displayed, the Flight Mode
switches will only operate as Normal, Stunt 1 and Stunt 2.
Flight Mode Switch Position
Extension Switch:
When set to INH
Extension
Position 0 (Above or Side Away from You)
Switch: When
set to 2P
Position 1 (Below or Side Towards You)
Switch
Position 0 (Above or Side Away from You)
Extension
Switch: When
Position 1 (Center Side)
set to 3P
Switch
Position 2 (Below or Side Towards You)
Setting Method
By rotating the dial to highlight the item that you wish to set,
then pressing the dial, the item will be in the selected condition.
Rotate the dial to select the switch that you wish to set from the
list that appears, and press the dial. In addition, the
be effective only during the Input Device Selection. By pressing
the
shown in the figure below).
0 1
Stunt 1 (ST-1)
Normal (NORM)
Stunt 1 (ST-1)
Normal (NORM)
Stunt 3 (ST-3)
Stunt 1 (ST-1)
Normal (NORM)
Stunt 3 (ST-3)
Stunt 4 (ST-4)
key the value will return to the initial condition (situation
Gear Channel Input Device and Output Condition
AUX2 Channel Input Device and Output Condition
AUX3 Channel Input Device and Output Condition
AUX4 Channel Input Device and Output Condition
AUX5 Channel Input Device and Output Condition
AUX6 Channel Input Device and Output Condition
Output Condition
(Whether or not the input device is used)
ACT: Send output from allocated
equipment
INH: Input invalid
(Input/output is disconnected)
GOV: Governor setting effective
GYR: Gyro setting effective
2
Stunt 2 (ST-2)
*In the situation where the switch
Stunt 2 (ST-2)
allocation has been changed, the
function of each switch will differ from
Stunt 4 (ST-4)
its name plate. Accordingly, care will
Stunt 2 (ST-2)
be required to avoid carrying out
Stunt 3 (ST-3)
mistaken operation during flight.
Stunt 4 (ST-4)
key will