PROGRAM MIX 1~6
This transmitter incorporates six systems of program
mixing. The three internal mixing systems 4-6 utilize curve
mixing that allows the mixing amount to be freely set using
an optional master channel position.
The display below shows the situation when Mixing 1 is
activated (ACT).
Before setting this item, first confirm whether or not the
Mixing 1-6 Normal Mixing Setting
Master Channel
Slave Channel
(Channel that applies
(Channel to which
the mixing)
mixing is applied)
Offset Amount (±200)
Channel Setting
By highlighting the Master channel (or Slave channel) part
and pressing the dial, the Channel Selecting screen will be
displayed. Select an optional channel from this screen.
Rotate the dial to match the channel that you wish to set,
and press the dial once again to determine it. At this time,
"CANCEL" will be displayed at the top right. If this key is
selected, the channel selection will return to the condition
that it was in before starting the selection.
(In the situation where the Master channel is to include
mixing using TRIM or D/R, a selection screen will be
displayed after the channel selection requesting whether
this mixing is to be included.)
Channels that are being set:
THROThrottle
LTALLeft tail
AILE Aileron
RTAL Right tail
ELEVElevator
RTHR Right throttle
RUDD Rudder
LTHR Left throttle
GEAR Gear (Retractable
RELERight elevator
landing gear)
LELE Left elevator
FLAP Flaps
RRUD Right rudder
AUX2Auxiliary (AUX2)
LRUD Left rudder
AUX3Auxiliary (AUX3)
RFLPRight flap
AUX4Auxiliary (AUX4)
LFLP Left flap
AUX5Auxiliary (AUX5)
RAL1 Right aileron 1
AUX6Auxiliary (AUX6)
LAL1 Left aileron 1
RAILRight aileron
RAL2 Right aileron 2
LAIL Left aileron
LAL2 Left aileron 2
LEVNLeft elevon
PIT. Pitch
REVN Right elevon
---- Setting invalid
Current Transmitter
Condition (Set to Pos0)
Throttle Stick Linkage Position
(INH, 0 to 100)
current positions of all the servos should be fixed (HOLD).
Because the throttle stick will be moved during the adjust-
ment afterwards, select "YES" if adjustment is to be carried
out while the engine is still rotating.
In the situation where this item is entered using Servo Hold,
set the throttle stick to the slowest position to exit from the
item.
Operation Switch Selection Method
Each program mixing can also be switched ON/OFF using
the optional lever switches. The display of the lever
switches that can be selected, and the positions when they
are set to ON are as described below.
Note: In the situation where the Flight Modes and SPS have
not been set, each of these will be displayed in gray,
and setting will not be possible.