JR ProPo DSX11 Operation Manual page 59

Tail Lock Mode
In the situation when using a gyro with a tail lock (heading
lock), tail lock will be set when the output amount is 50% or
greater, while normal will be set when the amount is less
than 50%. By highlighting the "NORMAL" part and pressing
the dial, "T.LOCK" will be displayed and it will be possible to
easily carry out sensitivity adjustment of the gyro with tail
lock.
Press the dial
: Normal Gain
: Tail Lock Gain
Dual Gain
Gyros such as this company's G7000 Gyro allow the sensi-
tivity setting channel and the strength of the effect during
Tail Lock to be set using separate channels. By using this
function, it will be possible to support any situation.
Press the dial
Setting Values and Actual Output Values
0%
NORMAL
-100%
T
T.LOCK
-100%
N
-150%
0%
NORM GAIN
DUAL GAIN
-100%
T.LOCK
-100%
When in this condition, a "T" mark will be displayed on the
left side of the sensitivity display, and switching between the
Normal side and the Tail Lock side will be possible using
this part. In addition, the "DELAY" setting has a function that
delays the change in the time setting that was set only in the
situation when changing from the low sensitivity side to the
high sensitivity side.
By rotating the dial to select the "TWO GYRO" part shown
in the figure above, then pressing the dial, this function will
be selected.
Normal Gain Adjustment
The upper numerical values are the
setting values.
0%
125%
0%
0%
100%
0%
100%
OFF
0%
100%
Tail Lock Gain Adjustment
Normal/Tail Lock
Changeover Key
Switching between
these is carried out
by pressing the dial.
150%
150%