Trim System; Thro Trim - JR ProPo DSX11 Operation Manual

(System Setting Mode)

Trim System

Trim Operation
Amount
In this function, setting is carried out of each trim operation
amount and the operation type.
Each trim is adjusted between 1 and 10 as the operation
amount that was moved in one step (The amount moved
when one click is heard).
Pressing the key will set the initial value of 4. Further,
regardless of the setting value set here, when passing
through the neutral point due to the trim operation, the
increasing and decreasing will temporarily stop at the
neutral position (Center Click function).

THRO TRIM

Switch Selection
In this function, the Throttle Cut and Throttle Trim Memory
operations are set.
Throttle Cut
It is not possible to set Throttle Cut and Throttle Trim
Memory to ACT (activated) at the same time.
In Throttle Cut, it is possible to select the Throttle Position,
Time Lag, and the switches.
Use the Time Lag in situations such as where you wish to
jointly use the Timer Switch with the switches. By setting the
selected switch, when the time becomes continually ON,
the Throttle Cut will operate.
In the situation where Twin Engine has been set in the Wing
Type (System Setting), each engine can be set.
Trim Type Setting
Trim Type
It is possible to change the operation type of the aileron,
elevator, and rudder trim. Rotate the dial to highlight the
name of the channel that you wish to change. Then press
the dial in this condition to change over the corresponding
switch.
"NORM" is the Normal trim operation. The entire servo
operation range will be changed.
In "L.S.T" (Limit Stroke Trim), the trim amount set at each
stick center (neutral) position will be the maximum, while the
effect of the trim will disappear at the stick end positions.
Accordingly, the maximum control surface angle determined
by the right and left control surface angle adjustment will not
be changed by the trim amounts.
Throttle Down Amount (-20 to 50%)
Time Lag Setting
Throttle Trim Memory
In the situation where the Throttle Trim Memory has been
set to ACT, limited to the case where the Throttle Trim is
moved once down to its lowest position, the trim position
immediately prior to the movement will be memorized.
Afterwards, when the trim is raised, it will move to the
memorized position.
Switch Selection
Stunt Trim:
(Only when setting using Device Select)
This determines whether the trim is applied
to all modes jointly, or whether it is set for
each Flight Mode.
Throttle Trim Memory
*This cannot be set at the
same time as Throttle Cut.