Throttle Hold - JR ProPo DSX11 Operation Manual

THROttle HOLD

By setting this function to active, in the standard condition it
will become possible to use the Throttle Hold switch at the
top left rear of the panel, and Autorotation can be carried
out. In addition, it will be possible to carry out setting of an
optional Pitch Curve when the independent Throttle Hold is
applied.
When "INH" is displayed, this function will be in the inhibited
Press the dial.
The Throttle Hold position value will be the throttle position
when Hold is applied, and has a variable width between -20
and +50% (corresponding to the Throttle Curve output
value). In the Throttle Curve, because the minimum output
value during idling will be zero, if the value is set to lower
than this (a minus value in this case), it will be possible to
set the throttle to the fully closed position and stop the
engine.
Further, using "SW SEL", it will be possible to change the
Hold switch. (Multiple selection is possible)
Stick Auto
It is possible to link Throttle Hold to the throttle stick. In this
function, in the condition where the Hold switch has been
set to ON, setting the throttle stick to less than the setting
value will result in the Hold condition. The Hold condition
will be maintained until the Hold switch is set to OFF.
This function is for delaying the throttle servo movement in
order to prevent a sudden increase in engine rotations in
the situation where the Throttle Hold switch has been set to
OFF in cases such as when you wish to redo the settings
during Autorotation. The delay width is between 0.1
second and 2.0 seconds. When the delay is used, the
Throttle Servo Speed setting will become impossible.
condition and cannot be used. In the case where you wish
to use the function, pressing the dial will set it to the active
condition. When setting the numerical values, rotate the
dial while in the ACT (active) condition to highlight "HOLD
POS.". Clicking the dial in this condition will change to the
Numerical Value Setting condition.
In the situation where the Hold switch
is ON, "ON" will be displayed.
Throttle Hold Position
Delay Time
Stick Auto Setting
Item Selection Condition
Press the dial.
Numerical Value Setting Condition (-20
to 50%)
By rotating the dial, it will be possible to
increase and decrease the numerical
values.
Using the
set the value to the preset value (-5.0%).
Item Selection Condition
Press the dial.
Numerical Value Setting Condition (INH,
0 to 100)
By rotating the dial, it will be possible to
increase and decrease the numerical
values.
Using the
set the value to the preset value (INH).
Item Selection Condition
Press the dial.
Numerical Value Setting Condition (INH,
0.1 to 2.0 s)
By rotating the dial, it will be possible to
increase and decrease the numerical
values.
Using the
set the value to the preset value (INH).
Switch
Selection
key, it will be possible to
key, it will be possible to
key, it will be possible to