Bearing Outer Race Replacement - Honda CR-V 1997 Service Manual

Differential
Bearing Outer Race Replacement
Note th ese item s:
• Th e bearing outer ra ce and tapered roller bearing
should be replaced as a set.
• Inspect and adjust the tapered roller bearing preload
whenever the tapered roller bearing is replaced.
" Remove the oil seals from the transmission housing
and clutch housing (see page 13-431.
2. Drive the bearing outer race and thrust shim out of
the transmission housing, or remove the bearing
outer race and 75 mm shim from the clutch housing
by heating the clutc h housing to about 212° F
(100°CI with a heat gun . Do not reuse the thrust
shim
if
the outer race was driven out.
TRANSMISSION
HOUSING:
ATTACHMENT.
52x55mm
077'6 - 0010400
THRUST SHiM
_~~~~~. < ;I
BEARING
OUTER RACE
CLUTCH
HOUSING:
13-40
HANDLE
07749 - 0010000
3. Install the thrust shim or 75 mm shim and the bear-
ing oute r ra ce in th e transmission housing and
clutch housing using the speci al tools.
Note these items during bearing replacement:
• Install the bearing outer race squarely.
• Check that there is no cl earan ce between the
bearing outer race, thrust shim or
75
mm shim
and housi ng.
TRANSMISSION
HOUSING:
ATTACHMENT.--f,,t;,,,
62 )( 68 mm
~?t~~;;~
077'6 - 0010500
BEARING
DUTERRACE
CLUTCH
HOUSING:
BEARING
OUTER RACE
7S mmSHtM
HANDLE
077<19 - 0010000
THRUST SHIM
HANDLE
077<19 - 0010000
ATTACliMENT.
72)( 75 mm
077'6 - 0010600
4. Install the o il seal (see page 13-43).