Honda CR-V 1997 Service Manual page 769

17. Install the sub-shaft assembly in the transmission
housing (see page 14-210 and 14-2111.
18. Install the ATF magnet (4WD) in the transmission
housing, if necessary.
19. Install the reverse idler gear and gear shaft holder
(see page 14-2311.
20. Install the differential assembly in the torque con-
verter housing.
21. Assemble the mainshaft and countershaft sub-
assembly (see page 14-206 and 14-2071. then install
them together in the torque converter housing.
MAINSHAFT
SUB-ASSEMBLY
COUNTERSHAFT
SUB-ASSEMBLY
22. Turn the shift fork so the large chamfered hole is
facing the fork bolt hole, then install the shift fork
with the reverse selector and torque the lock bolt.
Bend the lock tab against the bolt head.
6
x
1.0 mm
14 N·m
11 .4 kg!'m, 10 Ibl'h)
large chamfered
hole
faces this way .
23. Install the reverse gear with the collar and needle
bearing on the countershaft.
24. Align the spring pin on the control shaft with the
transmission housing groove by turning the control
shaft.
SPRING PIN
CONTROL SHAFT
TRANSMISSION HOIISlNIG
25. Place the transmission housing on the torque con-
verter housing with a new gasket and the three
dowel pins.
Make sure that the mainshaft speed sensor is not
installed on the transmission housing befor e
installing the tran smission housing on the torque
converter housing.
26. Install the transmission housing mounting bolts
along with the transmission hanger and the connec-
tor bracket. then torque the bolts in two or more
steps in the sequence shown.
NOTE: The illustration shows the 4WD automatic
transmission. The 4WD has 19 transmission hous-
ing mounting bolts; the 2WD has 18 bolts.
TORQUE: 44 N'm (4.5 kgf·m, 33 IbHt)
CONNECTOR
BRACKET
TRANSMISSION
HANGER
(cont'dl
14-253