Honda CR-V 1997 Service Manual page 758

Transfer Assembly
Reassembly (cont'd)
7. Secure the transfer housing in a bench vise with
soft jaws. then install the special tool on the com·
panion flange . To prevent damage to the transfer
housing, always use soft jaws or equivalent materi-
als between the transfe r housing and the vise.
8. Tighten the locknut while measuring the starting
torque so the starting torque is within 0.98 - 1.39
N·m (10.0 - 14.2 kgf·cm, 8.68 - 12.3Ibf·in).
NOTE:
• Coat the threads of the locknut. and the shaft
with ATF before installing the locknut.
• Do not stake the locknut in this step.
STARTING TORQUE:
0.98 - 1.39 N'm
(10.0 -14.2 kg/·em, 8.68 - 12.3 Ibl·in)
COMPANION FLANGE
HOLDER
07RAB- TB4010A or
07RAB - TB4010B
\
TORQUE
WRENCH
14-242
9. Install the transfer shaft in the transfer housing,
then install the tapered ro ller bearing. transfer shaft
collar, 25 mm thrust shim, transfer drive gear, coni-
cal spring washer, and locknut on the transfer shaft.
NOTE:
• Coat the threads of the locknut, and the shaft
with
ATF
before installing the locknut.
• Do not stake th e locknut in this step.
TAPERED ROLlER
BEARING
THRUST
25mm
Selective part
Replace .
TR',NSFER SHAFT
TRANSFER
, TRAINSI'ER SHAFT
COLLAR
"TIRA~ISFI'R
DRIVE
GEAR
CONICAL SPRING
WASHER
Replace.