Slave Cylinder - Honda CR-V 1997 Service Manual

Slave Cylinder
Removal/Installation
CAUTION:
• Do not spill brake
fluid on the vehicle;
it
may damage
the paint; if brake fluid does contact the paint, wash
it off immediately with water.
• Plug the end of the clutch line with a shop towel to
prevent brake fluid from coming out.
_ 1!ijiDjffi:
Super High Temp Urea Grease (PIN 08798-
9002).
~:
Brake Assembly Lube or eq uivalent rubber
grease.
1. Disconnect the clu tch line from the slave cylinder.
CLUTCH
2. Remove the slave cylinder from th e clutc h housing.
12-6
3. Install the slave cy linde r in the reverse order of
removal.
NOTE: Make sure the boot is installed on the slave
cylinder.
- I!ijiDjffi
IPIN 08798 - 90021
CLUTCH LINE
15 N'm (1.5 kgf·m, 11lbf.ft)
(Brake Assembly
lube)
8xl .2S mm
22 N·m 12.2 kgf·m.
16 Ibf.ft)
4. Bleed the clutch hydraul ic system.
• Attach a hose to the bleeder screw, and suspend
the hose in a container of brake fluid .
• Make sure there is an adequate supply of fluid at
the clutch m aster cyl inder, then slowly pump the
clutch pedal until no more bubbles appear at th e
bleeder hose.
• Refill the clutch ma ster cylinder with fluid when
done.
• Always use Genuine Honda DOT3 Brake Fluid.
Using a non -Honda brake fluid can cause co rro-
sion and decrease the life of the system.
• Confirm clutch operation, and check for leaking
fluid.
BLEEDI,R SCREW
7.8 N·m (0.8 kgf·m. 5.8 Ibf.ftJ