Honda CR-V 1997 Service Manual page 446

Transmission Assembly
Removal
sure jacks and safety stands are placed proper-
Iy, and hoist brackets are attached to correct position
on the engine.
• Apply parking brake and block rear wheels so vehicle
will not roll off stands and fall on you while working
under it.
CAUTION: Use fender covers to avoid damaging painted
surfaces.
1. Disconnect the negative (-) cable first. then the pos-
itive
(+)
cable from the batlery.
2. Remove the intake air duct and air cleaner housing
(see section
5).
3. Remove the slave cylinder and clutch hose bracket.
NOTE:
• Do not operate the clutch pedal once the slave
cylinder has been removed.
• Take care not to bend the clutch line.
CLUTCH HOSE
BRACKET
SLAVE
CYLINDER
4. Disconnect the starter cables and transmission
ground cable.
TRANSMISSION
GROUND CABLE
STARTER
CABLES
5. Disconnect the back-up light switch connector and
wire harness clamp.
WIRE HARNESS CLAMP
(cont'd)
13-7