Front Brake Pads; Inspection And Replacement - Honda CR-V 1997 Service Manual

Front Brake Pads
Inspection and Replacement
use an air hose or dry brush to clean brake
assemblies .
• Use an OSHA approved vacuum c::leaner to avoid
breathing brake dust.
1. Loosen the front wheel nuts slightly, then raise the
vehicle. and make sure it is securely supported .
Remove the front wheels.
2. Remove the caliper bolt. and pivot the caliper up
out of the way. Check the hoses and pin boots for
damage and deterioration.
CALIPER
BOLT
CALIPER BODY
3. Remove the pads, pad shims, and pad retainers.
INNER PAD SHIMS
Check for weakness.
, ".".
,c..; ~~~I--'
I
JY'/~ ~
,L.V; (,if~ \ '\
1'--1.
r~' (~';(I . ~ :~.~~
, '.;
--r ~ .s.D
V"' " ......- "-
( \ , \;,,>~ ,/ '\
a
O
f
~. '\~ ~ y/ " :;~~/
/"
/1i'I'/ ~/
;/
/
\
~/)'
{ \ 1- /
\ f!j/
\
~ / o r
a
INNER PAD
Check for wear
OUTER PAD /
Check for wear
OUTER PAD SHIM
Check for weakness.
4. Using vernier calipers, measure the thickness of
each brake pad lining. The measurement does not
include the pad backing plate thickness.
5.
Brake Pad Thickness:
Standard: 10.5 -11.5 mm (0.41 - 0.45 in)
Service Limit: 1.6 mm (0.06 in)
BACKING PLATE
If the brake pad thickness is less than the service
limit, replace the front pads and shims together
as
a
set.
6. Clean the caliper thoroughly; remove any rust, and
check for grooves and cracks.
7. Check the brake disc for damage and cracks.
8. Install the pad retainers.
PAD RETAINERS
(cont'd)
19-9