Honda CR-V 1997 Service Manual page 170

Oil Seals
Installation (cont'd)
4. Measure the flywheel-end seal thickness and the oil
seal housing depth . Using the special tool, drive the
flywheel -end seal into the rear cover to the point
where the clearance between the bottom of the oil
seal and the right side cover is 0.5 - 0.8 mm (0.02 -
0.03 in) (see page 7-19). Align the hole in the driver
attachment with the pin on the crankshaft.
76x80mm
07948 - 5800101
In stall seal with the
number side facing
out.
7-24
DRIVER
07749 - 0010000