Honda CR-V 1997 Service Manual page 469

Countershaft Assembly
Clearance Inspection (cont'd)
4. Measure the clearance between the 2nd gear and
3rd gear.
Standard: 0.07 - 0.14 mm (0.003 - 0.006 in)
Service Limit: 0.18 mm (0.007 in)
FEELER
GAUGE
1
[
}-
5. If the clearance is more than the service limit, mea-
sure the thickness of the spacer.
Standard: 29.07 - 29.09 mm (1.144 -1.145 in)
13-30
6. If the thickness is less than the standard, replace the
spacer with a new one.
If the thickness is within the standard, measure the
thickness of the 2nd gear.
Standard: 28.92 - 28.97 mm (1.139 -1.141 in)
• If the thickness of 2nd gear is less than the stan-
dard, replace 2nd gear with a new one .
• If the thickness of 1st gear is within the standard,
replace 1st/2nd synchro hub with a new one.