Flywheel - Honda CR-V 1997 Service Manual

Flywheel
Inspection
1. Inspect the ring gear teeth for wear and damage.
2. Inspect the clutch disc mating surface on the fly-
wheel for wear, cracks. and burning.
3. Measure the flywheel runout using a dial indicator
through at least two full turns. Push against the fly-
wheel each time you turn it to take up the crank-
shaft thrust washer clearance.
NOTE : The runcut can be measured with engine
installed.
Standard (Newl: 0.05 mm (0.002 inl max.
Service Limit: 0.15 mm (0.006 inl
If the runcut is more than the service limit, replace
the flywheel and recheck the runout.
flYWHEEL
DIAL INDICATOR
\
/
RING GEAR
4. Turn the inner race of the flywheel bearing w ith your
finger. The bearing should turn smoothly and qui-
etly. Check that the bearing outer race fits tightly in
the flywhee1. If the race does not turn smoothly, qui·
etly, or fit tight in the flywheel , replace the bearing.
FLYWHEEL
Replacement
1. Install the special tool as shown.
2. Remove the flywheel mounting bolts in a crisscross
pattern in several steps, and remove the flywheel.
MOUNTING
BOLTS
FLYWHEEL
RING GEAR HOLDER
07LAB - PV00100
or
07924 - PD20003
3. Remove the ball bearing from the flywheel.
FLYWHEEL
/
BALL BEARING
(cont'dl
12-9