Honda CR-V 1997 Service Manual page 379

3. Before connecti ng a new fuel tube/quick·connect fit·
ting assembly, remove the old retainer from the
mating pipe.
With the
tabs pulled
apart, remove
and
discard
the retainer
New FUEL TUBEI
QUICK-CONNECT
FITTING ASSEMBLY
4. Align the quick·connect fittings with the pipe. and
align the retainer locking pawls with the connector
grooves. Then press the quick·connect fittings onto
the pipe until both retainer pawls lock with a cl ick·
ing sound.
NOTE: If it is hard to connect, put a small amount of
new engine oil on the pipe end.
RETAIl'ER
Reconnection to existing retainer:
5. Make sure the connection is secure and that the pawls
are firmly locked into place; check visually and by
pulling the connector.
CONNECTOR
6. Reconnect the battery negative cable, and turn the
ignition switch ON (II), The fuel pump will run for
about two seconds, and fuel pressure will rise. Repeat
two or three times, and check that there is no leakage
in the fuel supply system.
11-177