Illustrated Index - Honda CR-V 1997 Service Manual

Illustrated Index
- , Lubricate all internal parts with engine oil during reassembly.
A.pply
liquid gasket to the mating surfaces of the right side cover and oil pump case before installing them.
Jse liquid gasket, Part No. 08718 - 0001 or 08718 - 0003.
::Iean the oil pan gasket mating surfaces before installing the oil pan.
DRAIN BOLT WASHER
6x 1.0 mm
/ 1 2 N'm 11.2 kgf·m, 8.7 Ibf.ftl
4-4 N'm 14.5 kgf·m, 33Ibf.fll _ _ _ _ ••
~~RePlace.
OIL PAN GASKET
Replace.
9.8 N·m 11.0 kgf·m, _ _ _ _ _
e:I
OIL PAN
Refer to page 7-22
when installing
l1xl.5mm
76 N·m (7.8 kgf·m. 56 IbMt)
Apply engine oil to the bolt
threads.
NOTE: After torquing
each cap, turn the crankshaft
to check for binding.
7.2 Ibf·ftl
~ ~.'
//:.
BAFFLE PLATE _ • / •
MAIN BEARING CAP
DOWEL PIN
MAIN BEARINGS / / / / /
Selection, page 7-8
NOTE: New main bearings must
be selected by matching the crank
and block identification markings.
OIL SCREEN
6xl.0mm
9.8 N·m (1.0 kgf·m,
7.21bf.fll
GASKET
Replace.
OIL PUMP
Overhaul, page 8-8
Removal/Inspection,
page 8-9
Apply liquid gasket
to mating surface.
CRANKSHAFT SEAL
Installation, page 8-10
Replace.
~
6x 1.0mm
9.8 N·m 11.0 kgf·m, 7.2 Ibf.fl)
O-RING
Replace.
CRANKSHAFT
Inspection, page 7-11
CRANKSHAFT OIL SEAL
THRUST WASHERS
Check for cracks.
6x 1.0 mm
9.8 N'm 11.0 kgf·m, 7.21bf.fll
RIGHT SIDE COVER
Apply liquid gasket
to mating surface.
Grooved sides face outward.
NOTE: Thrust washer thickness
is fixed and must not be changed
by grinding or shimming.
(conl'd)
7-3