Honda CR-V 1997 Service Manual page 888

20. Press the new bearing into the valve housing with
the stamped letter facing up using a hydraulic press
and special tool.
DRIVER
07749·0010000
Press
...
ATTACHMENT,
32x35mm
07746 - 0010100
ROLLER BEARING
Letter stamped face
upward.
21. Apply vinyl tape to the pinion shaft, then coat the
vinyl tape with power steering fluid.
i.
Sealing lip face.
SLEEVE SEAL
Be sure that the
seal rings are not
turned up, then
install.
VALVE OIL SEAL
VALVE HOUSING
PINION SHAFT
i.
22. Insert the pinion shaft into the valve housing. Be
careful not to damage the valve seal rings.
23. Remove the vinyl tape from the pinion shaft, then
remove any residue from the tape adhesive.
24. Press the pinion shaft/sleeve using a hydraulic
press. Check that the pinion shaft/sleeve turns
smoothly by turning the pinion shaft.
Press
(cont'd)
17-43