Brake Shoes Replacement - Honda CR-V 1997 Service Manual

Rear Drum Brakes
Brake Shoes Replacement
1. Remove the upper return spring with the tool.
Wear eye protection when using the
wrench.
RETURN SPRING
RETAINER SPRING
BRAKE SPRING WRENCH
(Commercially available)
TENSION PIN
2. Remove the tension pins by pushing the retainer
spring and turning them.
3. Lower the brake shoe assembly. and remove the
lower return spring. Make sure not to damage the
dust cover on the wheel cylinder.
4. Disconnect the parking brake cable from the parking
brake lever.
5. Remove the brake shoe assembly.
6. Remove the upper return spring, self-adjuster lever.
and self*adjuster spring, and separate the brake
shoes.
19-18
LOWER RETURN
SPRING
UPPER RETURN SPRING
PA~IKINIG
BRAKE LEVER
7. Remove the wave washer, parking brake lever, and
pivot pin from the brake shoe by removing the U-
clip.
U-CLIP
Replace.
~
PARKING
BRAKE
LEVER
WAVE WASHER
Replace.
BRAKE SHOE
PIVOT PIN
8. Apply brake cylinder grease (PIN: 08733 - 80202) or
equivalent rubber grease to the sliding surface of
the pivot pin, and insert the pin into the brake shoe.
9. Install the parking brake lever and wave washer on
the pivot pin, and secure them with a new U-clip.
• Install the wave washer with its convex side fac-
ing out.
• Pinch the U-clip securely to prevent the pivot pin
from coming out of the brake shoe.
U-CLIP
Replace.
PARKING BRAKE
LEVER
WAVE WASHER
Replace.
PIVOT PIN