Honda CR-V 1997 Service Manual page 777

17 . Install the right and left driveshafts (see section 181.
While installing the right driveshaft in the differen-
tial, be sure not to allow dust or other foreign parti -
cles to enter the transmission.
NOTE:
• Clean the areas where the right driveshaft con-
tacts the transmission (differential) with solvent
or carburetor cleaner, and dry with compressed
air .
• Turn the right and left steering knuckle fully out-
ward, and slide the right driveshaft into the dif-
ferential until you feel its spring clip engage the
side gear. Slide the left driveshaft into the inter-
mediate shaft until you feel the spring clip of the
intermediate shaft engage the left driveshaft.
18. Install right damper fork, then install the right and
left ball joints on each lower arm with the castle
nuts and new cotter pins (see section 18).
DAMPER PINCH BOLT
10 x 1.25 mm
43 N'm (U kg/·m,
32lbf.ftl
DAMPER
FORK
SCLF-LOCKING NUT
12:11 1,25 mm
64 N·m (6.5 kg/'fft, 47 Ibf"'1
Replace.
CASnENUT
12 x 1.25 mm
49 -59 N·m
\- C !ERPIN
Replace.
(5.0 - 6.0 kg/om, 36 - 43 Ibf.ftl
19. Install the propeller shaft to the transfer assembly
by aligning the reference marks (4WD).
8x1.25mm
32 N·m (3.3 kgf-m, 241bf.ftJ
Replace.
PROPELLER SHAFT
20. Install the shift cable .
4WD:
REFERENCE MARKS
TRANSFER
Install the shift cable with the control pin , then
secure it w ith the snap pin. Do not bend the shift
cable excessively.
PIN
CONTROL
LEVER
SHIFT CABLE
COVER
"n'ITA'" PIN
"SX12smm
22 N'm (2.2 kg/·m,
16lbf-ftl
(cont'dl
14-261