Clearance Measurement - Honda CR-V 1997 Service Manual

3. Install the reverse selector hub on the countershaft
sub-assembly, and press the hub using the special
tool and a press as shown.
PRESS
DRIVER 00 mm 1.0.
07746 - 0030100
REVERSE SELfCTOR
HUB
COUNTERSHAFT
SUB-ASSEMBLY
Inspection
Clearance Measurement
NOTE: Lubricate all parts with ATF during assembly.
1. Remove the countershaft bearing from the trans-
mission housing (see page 14-227).
2. Assemble the countershaft parts using the special
tool and a press as described on this page. Do not
install the O-rings during inspection.
RE'VEIISE SELECTOR
4TH GEAR
/'N ..
'UL .•
BEARING
DISTANCE COLLAR, 2B mm
Selective part
2ND GEAR
THRUST NEEOLE BEARING
.... OIEEIDLE
BEARING
GEAR COLLAR
NEEDLE BEARING
_S,PLlNE'D
WASHER
CLUTCH ASSEMBLY
(cont'd)
14-207