Day/Night Mode Schedule Per Tenant Assignment - Toshiba CTX100-S Programming Manual

113 Day/Night Mode Schedule per Tenant Assignment

Prerequisite Program:
The Day/Night Mode daily schedule defines the times for the start of the Work Day, Non-work Day, and
Holiday for each of the modes (Day, Day2. Night) per Tenant. Each "type of day" defined in
Night Mode "Type of Day" Mapping Table Assignment"
Complete "Day/Night Mode Record Sheet"
The start time for Day 1 mode equals the end time for Night mode.
Note
F
IELD
Tenant Number
Work Day
•
01 Day 1 Mode
•
02 Day2 Mode
• 03 Night Mode
Non-Work Day
•
04 Day 1 Mode
•
05 Day2 Mode
• 06 Night Mode
Holiday
•
07 Day 1 Mode
• 08 Day2 Mode
• 09 Night Mode
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
None
on page
D
ESCRIPTION
Select the Tenant number for which the daily schedules will be configured. (This
feature is available with CTX R2.2 or higher and CTX WinAdmin R2.2G.0 and
higher.).
Possible values:1~8.
Enter the Day1, Day2 and Night Mode start time for Work Day day type.
Possible values: hhmm; hh = hour (00~23, 99), mm = minutes (00~59, 99)
(default = 9999)
Note 9999 deletes or skip modes.
Enter the Day1, Day2 and Night Mode start times for Non-Work Day day type.
Possible values: hhmm; hh = hour (00~23, 99), mm = minutes (00~59, 99)
(default = 9999)
Note Enter 9999 deletes or skip modes.
Enter the Day1, Day2 and Night Mode start times for Holiday Day day type.
Possible values: hhmm; hh = hour (00~23, 99), mm = minutes (00~59, 99)
(default = 9999)
Note 9999 deletes or skip modes.
on page 4-20 requires an assigned schedule.
D-8.
System
Day Night Service
"106 Day/
4-21