Toshiba CTX100-S Programming Manual page 422

Telephone Button Programming
900 Series Programs
Note The Shelf number is entered in "XX" format where Shelf is a two digit value from 01~07
corresponding to the Strata CTX Cabinet number. See
description of the LED display.
FB Name
Equipment
Slot #1
Slot #2
Slot #3
Slot #4
Slot #5
Slot #6
Slot #7
Slot #8
Slot #9
Slot #10
)%
1. Press
Access Sequence above.
Note The slot to which your programming phone is connected can not be set to Make Busy.
+ROG
2. Press
+ROG
3. Press
4. Press
5. Enter another program number to continue programming or press
mode.
Program Button LEDs
The LED blink pattern indicates the following:
• Red continuous blinking – PCB experienced a Make Busy status error.
• Red continuous illumination – PCB Make Busy Status mode is on.
• Green continuous blinking – PCB Make Busy Status mode is stand by.
• Green intermittent blinking – PCB Make Busy Status mode is idle.
13-108
FB
00 Enter Cabinet Number
01
02
03
04
05
Enter  or 
06
07
08
09
10
)%
~ to enter your Make Busy selection for the appropriate Slot in the Cabinet entered in
to execute.
again to return to
CABINET
+ROG
to return to the
PROG
"Program Button
Summary
01~07 (value=xx)
1: Set make busy
2: Clear make busy
= prompt.
= prompt.
Strata CTX Programming - Part 3: Telephone Button Programming 11/03
LEDs" below for a
Value
+ROG
again to exit programming