Toshiba CTX100-S Programming Manual page 188

Trunks
Trunk DID/DNIS Setup Wizard
F
IELD
Destination Type
Set the Dialing Digits
range
6-38
D
ESCRIPTION
Select the type of destination:
DISA - to call in and receive DISA dial tone.
Built-in modem - to call in directly to the CTX modem with CTX WinAdmin.
Night Bell - to call in and close the BIOU or ACTU night bell control relay.
Dialing Digits - to call in and:
•
Ring PDNs, PhDNs, and/or Pilot Numbers
•
Night Ring over External Page - feature access code must be included in the
dialing digits.
• Access outgoing CO lines, Network Nodes and/or LCR to set up tandem calls -
line access codes must be included in the dialing digits.
Notes
• When Dialing Digits is the selected Destination Type, you must set the Dialing
Digit Range below.
• This selection will override any GCO or Pool Key Group assignment made in this
Program or Program 304, ILG assignments.
Select the method in which dialing digit ringing destinations should be created:
Use DNIS as Destination - the destination digits for each DID/DNIS number will be the
same as the DID/DNIS number. This option is normally used when the DID/DNIS
numbers match the telephone PDNs, PhDNs etc.
Start with - enter the number to which the first selected DID/DNIS number should ring.
Ringing destinations will be assigned consecutively, starting with this number, to each
consecutive DID/DNIS number.
Only Use - all selected DID/DNIS numbers will be assigned to the dialing digits
entered here.
Add to front - these digits will be added in front of each dialing digit number.
Add to End - these digits will be added to the end of each dialing digit number.
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03