Telephone Button Programming
900 Series Programs
Table 13-41
Program 804
Button
Sequence
804
RS232C Data
Assignment
'#
Cyq
,
804-00
BSIS Port
Cyq
n,
804-01
Port Speed
A7
Cyq
, n,
804-02
Port Parity
A7!
Cyq
, n,
804-03
Data Bits
A7"
Cyq
, n,
804-04
Flow Control
A7#
Cyq
, n,
804-05
Wait Timer
A7$
Cyq
, n,
,
900 Series Programs
These programs are organized based on functions versus program numbers.
System Initialize
This program enables you to reset hardware and initializes, or restores programmed data.
Program Number(s): 900
Prerequisite Program:
Reference:
Access Sequence:
FB Name
Initialize Level
13-96
Value(s)
n =
1~4 (default = no value)
n =
1. 300
2. 1200
3. 2400
4. 4800
5. 9600 (default)
6. 19200
7. 38400
8. 57600
n =
1. None
2. Even
3. Odd (default)
n =
1. 7 Bits (default)
2. 8 Bits
n =
1. None (default)
2. Flow
n =
0~255
Cyq
(default = 30 seconds)
None
None
Login to programming mode from your telephone button pad:
+ROG
.
At the PASSWORD= prompt, Enter your password and press +ROG.
At the PROG= prompt enter and press +ROG.
FB
Press or to select the initialize level.
01
Level 1 – Erases programmed data and
enters default data or backed up data if a
SmartMedia Card is installed (see Note).
Level 2 – Simulates System Power Off/Power
On operation to reset hardware.
Use this screen to setup the RS-232 serial Ports on the BSIS
interface PCB.
Enter the BSIS PCB port number.
This is the data speed of BSIS port in bits per second (bps).
Note
The total combined maximum speed of BSIS ports cannot
exceed 57,600 bps.
This is the parity error checking methods used by the BSIS port.
This is the number of data bits used for each data block.
This is the type of flow control used between the BSIS port and the
SMDI or SMDR device. Must be set to "FLOW" in order for the CTX to
buffer call records.
Maximum time to wait for connection.
1. 0 means wait permanently
2. Timer value can be 1-255 seconds.
Summary
Strata CTX Programming - Part 3: Telephone Button Programming 11/03
Summary
Value
LCD Prompt
1. Initialize Level 1
1:Restart with
Clear Data
2. Initialize Level 2
2:Restart