Toshiba CTX100-S Programming Manual page 377

Table 13-28 Programs 303~315 (continued)
Button Sequence
313-01 Signalling Method
A7 C‚yq
, n,
313-02 Signalling Contents
A7! C‚yq
, n,
313-03 CLASS Equipment
Position
A7" C‚yq
, xxyyzz,
315 T1 Trunk Card
" " C‚yq
,
315-00 T1 Equipment
Location
C‚yq
xxyy,
315-01 Coding Format
A7 C‚yq
, n,
315-02 Frame Format
A7! C‚yq
, n,
315-03 Time Slots
315-04 Receive PAD
A7$ C‚yq C‚yq
, n, ,
Strata CTX Programming - Part 3: Telephone Button Programming 11/03
Value(s)
n = 1. None (default)
2. ANI/DNIS-MCI
3. ANI/DNIS-Sprint
4. CLASS (Caller ID)
n = 1. ANI and DNIS (default)
2. ANI only
3. DNIS only
4. DID only
xx = Cabinet 01 (CTX100),
01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
yy = Slot 01~8 (CTX100),
01~10 (CTX670)
zz = Circuit 01~08
xxyy xx = Cabinet 01,
yy = slot 01, 03, 05, or 07
...or xx = Cabinet 02~07,
yy = slot 01, 03, or 05
n = 1. None
2. PZC
3. B8ZS (default)
4. ZCS
n = 1. None
2. SF mode
3. ESF mode (default)
n = 1. None
2. 8 Time Slots (default)
3. 16 Time Slots
4. 24 Time Slots
n = 1. None
2. Plus 6 dB
3. Plus 3 dB
4. Zero dB (default)
5. Minus 3 dB
6. Minus 6 dB
7. Minus 9 dB
8. Minus 12 dB
9. Minus 15 dB
Telephone Button Programming
Summary
Specify the format for the interface being used.
Specify the contents of the ANI/DNIS format.
If the CLASS type is chosen, the trunk must be assigned to a Caller
ID circuit. Enter the RCIU/RCIS equipment number as xxyyzz.
Notes
•
CLASS equipment numbers are required when assigning a trunk
to a RCIU/RCIS circuit.
•
It can also be used to display the equipment location of existing
caller ID circuit to trunk assignments. Example: If the trunk should
be connected to a caller ID circuit (RCIU/RCIS) in cabinet shelf 5,
slot 2, circuit 3, enter 050203.
This command assigns T1 Trunk Card Data to the system.
Enter the RDTU PCB equipment location as xxyy:
Example: If the RDTU is installed in cabinet shelf 5, slot 3, enter
0503.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each
Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
Select the Coding Format.
Select the Frame Format.
Set the number of Time Slots to be used.
Select the Receive PAD values.
300 Series Programs
13-63