Toshiba CTX100-S Programming Manual page 464

System Error Codes
Trunk Programming Error Codes
Program Code
33
33
33
48
49
49
49
49
49
49
49
49
49
302
49
49
49
50
52
54
80
80
80
80
96
B-14
Occurred Sub-
FB parameter
7
The equipment number entered is out of the range.
7"
The ILG entered is out of the range.
7#
The entered OLG is out of the range.
Dch position is not set to 16. When setting the time slot
7&
pattern for a 2048 kbps interface, this value must be set to 16.
7"
The type of ILG or OLG entered in not an ISDN.
7#
The ILG or OLG entered does not exist in the system.
When the equipment is moved, the number of the PCM
7
highway in the moved equipment is different from the current
equipment.
The ILG entered is not registered in the system.
-
FB which this error occur : FB03
The OLG entered is not registered in the system.
-
FB which this error occur : FB03
When the card type is "PTU1F", the protocol type entered
7!
should be "Bellcore" or "Bellcore Northern Telecom".
When the card type is "PTU", the protocol type entered is
7!
"ETSI".
7!
The card type is not "IPU-Q" when IP is selected.
The card type is not "PTU" or "PTU1F" when TTC or QSIG is
7!
selected.
When the card type is "PTU1F", the inputted D channel
7&
position is not 16.
D channel position must assign "0" when the card type is
7&
"IPU-Q".
D channel position must not be assigned "0" when the card
7&
type is not "IPU-Q".
The T-Wait Timer can only be enabled if the Protocol is set to
7!#
National ISDN.
The entered Channel Group conflicts with an existing ISDN
7
extension(s), etc.
The quantity of lines, ISDN channels and PDNs entered
7
exceeds the number of ports licensed with this processor.
The entered Channel Group number does not exist in the
7
system.
An ISDN trunk cannot be assigned to the designated Shelf/
7
Slot/Circuit.
7"
The designated ILG does not exist in the system.
7#
The designated OLG does not exist in the system.
The number of allowable Channel Groups has been
7
exceeded when a new ISDN trunk assignment is made.
Error Descriptions
Strata CTX Programming - Part 4: Appendices 11/03