Toshiba CTX100-S Programming Manual page 369

Table 13-26 Programs 300~302 (continued)
Button Sequence
302-29 29 2-B channel
Transfer
% +ROG
, n,
302-30 30 Q931 Protocol
Timer
% +ROG
, n,
Table 13-27 Bearer Services Table
unrestricted digital
information
Circuit
Mode
Packet
Mode
Table 13-28 Programs 303~315
Button Sequence
303
ISDN Trunk Delete
 +ROG
,
303-00 Channel Group
Number
+ROG +ROG
n, ,
304 Incoming Line Group
Assignment
 +ROG
,
304-00 Group Number
+ROG
n,
Strata CTX Programming - Part 3: Telephone Button Programming 11/03
Value(s)
n = 1. Enable
2. Disable
n = 1. Normal
2. Long
Bearer Services
Speech
3.1 KHz Audio
7 KHz Audio
64 kbps
Rate adaptation from 56
kbps
2x64
384kbp (H0)
1536kbps (H11)
1920kbps (H12)
multirate (n x 64 kbps)
Restricted digital Information
Video
Shelf/Slot/Circuit
Value(s)
n = 1~32 (CTX100)
1~48 (CTX670 Basic)
1~128 (CTX670 Exp.)
n = 1~32 (CTX100)
1~50 (CTX670 Basic)
1~128 (CTX670 Exp.)
Telephone Button Programming
Summary
Enable this option to allow 2-B channel conference on PRI calls. This
allows to PRI channels to be connected in the same conference or
Tandem call.
Note This option must also be enabled by PRI provider to allow it
to work.
Sets the Q931 Protocol Timer. If Long is set, T303 is 8s and T301 is
300s.
Nat'l ISDN ETSI
X X
X X
X
X X
X
X
X X
X X
X
X
X
X
Summary
This command deletes ISDN Trunks.
Enter the channel group number to delete.
This assignment is used to configure ILGs only, OLGs are configured
in the Outgoing Line Group Assignment 306. The same line can be
placed in an ILG and OLG.
Enter the group number of the line group that should be configured.
300 Series Programs
TTC
X
X
X
X
X
X
X
X
X
13-55