Toshiba CTX100-S Programming Manual page 173

F
IELD
03 ILG
04 OLG
06 Bearer Svc - Speech
07 Bearer Svc - 3.1 KHz
Audio
08 Bearer Svc - 7 KHz
Audio
09 Bearer Svc -
Unrestricted 64K
10 Bearer Svc -
Unrestricted 56K
11 Bearer Svc -
Unrestricted 2x64K
12 Outgoing B Ch Select
13 B Ch Selection
14 Initialize Type
15 Initialization Display
16 SPID #1
17 SPID #2
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
D
ESCRIPTION
ILG assignments must be made for basic ISDNs to process the calls being received.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = no value).
OLG assignments must be made for basic ISDNs to process the calls being
originated.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670 Exp),
(default = no value).
Enable speech capability. See
Possible values: Enable (default) or Disable
Enable 3.1 KHz audio capability. See
Possible values: Enable (default) or Disable
Enable 7 KHz audio capability. See
Possible values: Enable or Disable (default)
Enable one of the unrestricted capabilities. See
Possible values: Enable (default) or Disable bearer capabilities for the channel
group.
Possible values: Enable (default) or Disable
Select originating B Channel method.
Possible values:
•
Explicit – Channel is indicated, and no alternative is acceptable.
• Preferred – (default) Channel is indicated, and any alternative is acceptable.
•
Any Channel – Channel is indicated, and any channel is acceptable.
Choose Idle B Channel selection method.
Possible values: Forward Cyclic, Backward Cyclic, Forward Terminal or Backward
Terminal (default = Backward Terminal)
•
Select Forward Cyclic (from lowest number to highest number of B-channel).
• Select Backward Cyclic (from highest number to lowest number of B-channel).
• Select Forward Terminal for the lowest numbered B-channel.
Select Backward Terminal for the oldest number B-channel. (The High-High B-
channel selection)
Enter the Service Profile Identifier (SPID) type of initialization.
Possible values: User Entry (Auto SPID On), User Entry (Auto SPID Off), Auto SPID
or None (default)
Enter the text to be displayed for SPID Initialization.
Possible values: Up to 4 ASCII characters (default = User)
Enter the SPID value. These fields are required if you selected National ISDN in
Protocol. When no data is entered, any previously entered information is overwritten.
Possible values: Up to 20 ASCII characters (default = No Value)
Table 6-1 on page 24.
Table 6-1 on page 24.
Table 6-1 on page 24.
Table 6-1 on
Trunks
ISDN
page 24.
6-23