Trunk Programming Error Codes - Toshiba CTX100-S Programming Manual

Trunk Programming Error Codes

Program Code
33
33
33
33
49
49
49
49
300
49
49
49
54
80
80
80
96
96
33
301
80
Strata CTX Programming - Part 4: Appendices 11/03
Occurred Sub-
FB parameter
7
The equipment number entered is out of the range.
7!
The ILG entered is out of the range.
7"
The OLG entered is out of the range.
7 !
The hunting order entered is out of the range.
When modifying previously assigned equipment:
•
7
•
The ISDN ILG number is designated for analog trunks or the
7!
entered ILG number does not exist in the system.
7!
"0" was entered in ILG when OLG was not registered.
7!
The OLG entered is not registered in the system.
The ISDN OLG number is designated for analog trunks or the
7"
entered OLG number does not exist in the system.
7"
"0" was entered in OLG when ILG was not registered.
7!
A conflict exists between the ILG number and the OLG
7"
number trunk type.
The quantity of lines, ISDN channels and PDNs entered
7
exceeds the number of ports licensed with this processor.
A trunk number that does not exist in the system has been
7
selected.
7!
The entered ILG number does not exist in the system.
7"
The entered OLG number does not exist in the system.
7
Allowable number of trunks has been exceeded.
7
The line number entered exceeds the system's capacity.
7
The trunk number entered is out of the range.
A trunk number that does not exist in the system has been
selected.
Error Descriptions
The designated PCB Type does not allow CO trunk
assignments.
The designated circuit does not allow CO trunk
assignments.
System Error Codes
Trunk Programming Error Codes
B-13