Toshiba CTX100-S Programming Manual page 109

F
IELD
37 Set Call Forward
Dial Tone
38 Dialling Digit
Restriction
39 CO Park & Hold
40 MW & DND Dial
Tone
41 Activate Message
Waiting
42 Tenant Number
Strata CTX Programming - Part 2: CTX WinAdmin Programming 11/03
D
ESCRIPTION
When the handset is picked up, the user will hear stutter dial tone if a call forward is
enabled.
After the Extension has made a call it can be prevented from dialling any
subsequent digits.
You can enable or disable CO Park and Hold.
Note This feature is available for CTX Software version R1.03 or higher.
Enabled: When this station parks a line call, CO or GCO buttons of the parked line
that appear on other stations will be on hold. This will allow the other stations to
press the CO or GCO button to pickup the parked call.
Disabled: When this station parks a line call, CO or GCO buttons of the parked line
that appear on other stations will appear busy. This will prevent the other stations to
press the CO or GCO button to pickup the parked call.
Possible values: Enable or Disable (default)
Enable: When this station goes off hook, the station will receive stuttered dial tone
when it has a message waiting indication; and the station will receive a busy tone
burst before dial tone when in the DND mode.
Disable: This station will receive normal dial tone when it has a message waiting or
when it is in the DND mode.
This feature is available only with CTX Release 1.3 or higher software and with
CTX WinAdmin Release 1.3 or higher software.
Enable: This station is allowed to activate station-to-station message waiting on
other stations by dialing the other station number plus 7, 8 or 9; or, by pressing the
Msg key. This feature is available with Strata CTX R1.3 software.
Disable: This station cannot activate station-to-station message waiting on other
stations by dialing the station number plus 7, 8 or 9.
Notes
•
When disabled, digital telephones are still allowed to activate station-to-station
message waiting by pressing the Msg button.
• This parameter does not apply to Voice Mail ports to use the special Message
Waiting access codes.
Enter the Tenant number to which this PDN should be assigned. (This feature is
available with CTX R2.2 or higher and CTX WinAdmin R2.2G.0 and higher.)
Possible values: 1~8.
Station
Assignment
5-5